Neutralising the surface

Before using one of the TIG Brush neutralising liquids, rinse the cleaning liquid thoroughly with clean water.
Then apply the appropriate neutralising fluid, followed by a final water rinse to remove residual acid and prevent formation of a new surface
of "white frosting" on your finished product. White frosting can appear after many days, so it is important,
to follow this neutralising process as soon as possible after cleaning.

In addition, Ensitech fluids are NSF certified and meet the requirements of the NSF Non-Food Compounds Registration Programme.
The NSF mark is your assurance that Ensitech pre, post and weld cleaning fluids have been approved by one of the most respected independent organisations in the world
Certification organisations available today.

If you place a high priority on cleaning quality and speed, passivation and safety, use your TIG brush with genuine
Ensitech fluids. By following Ensitech's Surface Finishing System recommended procedures, you can count on superior
Results.